How to configure a Courier V.Everything 33.6 modem for various data transfer modes via a Linux box Note: You don't have to mess with any of the internal register settings for the modes listed below! Note that the configurations described below have... Read More
RedHat Linux
How To Configure PowerAlert on Linux with the APC BackUPS Pro 280VA (v2.0, 5Sept2002) This How-To explains the steps involved in setting up a Dell or Penguin computer system with Red Hat Linux v7.3 for use with the APC BackUPS Pro 280VA... Read More
How To Configure PowerChutePlus on Linux with the APC BackUPS Pro 280VA (v1.0, 7Feb2002 written by: Jay Sklar) This How-To explains the steps involved in setting up a Dell or Penguin computer system with Red Hat Linux v7.1 for use with the APC... Read More
How To Configure Nut v0.45.4-1 on Linux with the APC BackUPS Pro 280VA (v1.0, 27Sept2002 written by: Jay Sklar) This How-To explains the steps involved in setting up a Dell or Penguin computer system with Red Hat Linux v7.3 for use with the APC... Read More
HOWTO.2: How to configure for a remote terminal session to a Linux Box through a phone or wireless connection A: Phone connection For more information on the configuration setup for the US Robotics Courier V.Everything modems for this application,... Read More
HOWTO.3: How to configure PPP for serial TCP/IP phone or wireless connections between a local and remote Linux box A. Phone connection Note: It is a good idea to set up a basic dial-up connection and check that the serial link and mgetty program... Read More
HOWTO.4: GENPOWER and Power Monitoring Software Install A number of modified system initialization and shutdown scripts, as well as an automated GENPOWER install script have been bundled into this in-house release of the GENPOWER software. With this... Read More
HOWTO.5: Adding one or more serial cards to a Linux Box and avoiding IRQ and memory address conflicts. The information below can be used as general guidelines for the installation of any serial card; however the suggested recommendations were tested... Read More
HOWTO.6: Boot and mount problems: recovering from trashed file systems Troubleshooting booting problems with LILO: Case 1: The installation of LILO in the Master Boot record is not successful. If Linux replaces another operating system previously... Read More
ntp for RedHat Linux versions 5.2, 6.2, 7.1, and 7.3 ntp for RedHat Linux v7.3: ntp-4.1.1-1.i386.rpm ntp for RedHat Linux v7.1: ntp-4.1.1-1.i386.rpm (same as above) ntp for RedHat Linux v6.2: xntpd / xntpdc (not available on this site) ntp for RedHat... Read More