Skip to Content
| GAGE


Trimble R7/5700 Resource Page

Trimble R7/5700 Resource Page

Back to receiver comparison page
Receiver
GNSS ?
Available as special buy
Available on loan
Serviceable at UNAVCO
File Size (24 hr, 15 s)
Memory
Time lasts recording at 15 s
Power draw w/ antenna
Time lasts on 18amphr battery
Trimble R7
N

N

Y

Y

1 MB
-
128 MB - 2 GB CF card
-
4 mo. - 5.5 years or 512 files

3.7 W

2 days
Trimble 5700
N

N

Y

Y

1 MB
-
128 MB - 2 GB CF card
-
4 mo. - 5.5 years or 512 files

2.5 days

The 5700 and R7 receivers are very similar and are almost interchangeable. Significant differences are noted here. Because it is low-power, lightweight, can accommodate internal batteries, and is programmable via a survey controller, the 5700/R7 is ideal for kinematic surveys and campaign work in general.

  • Program using Trimble software for Windows systems (GPS Configurator, Configuration Toolbox), Trimble R-Utilities for a Windows, LINUX, or Solaris system, or a Trimble survey controller. Note: The survey controllers are not backwards compatible. The TSC1 controller must be used with the 5700 receiver. The TSC1, TSCe, or TSC2 controllers can be used with the R7 receiver.

  • Download directly off the removeable compact flash card, using Trimble Data Transfer Utility for Windows systems, or using Trimble R-Utilities for a Windows, LINUX, or Solaris system.

  • Data stored on a removeable compact flash card. Note that a maximum of 512 files can be stored, regardless of file size.

  • No screen; LED lights indicate operating mode.

  • 512 file limit for file storage, regardless of file size.

  • Accomodates internal batteries.

Trimble Resources

Software

Configuration files

  • The Trimble default configuration file
    Trimble’s default 5700/R7 configuration file remains on the receiver through its lifetime and cannot be erased. A hard reset of the receiver will erase any added configuration files but the factory default file remains and becomes the active configuration file. The default file configures the receiver with the following settings:

    • Elevation mask: 13 degrees

    • Logging interval: 15 seconds

    • Minimum SVs: 4

    • File duration: none

    • [No automatic data logging]

    This configuration creates one continuous data file. Data logging must be initiated manually by pressing the data logging button on the receiver. This is a potential problem for remote sites that may suffer intermittent power loss, as with a solar panel.

  • UNAVCO standard configuration file (.cfg)
    The UNAVCO standard configuration file is loaded onto each 5700 or R7 receiver and is the active configuration file unless recipients of loaned UNAVCO equipment request otherwise. The UNAVCO standard configuration file programs the receiver with the following settings:

    • Elevation mask: 5 degrees

    • Logging interval: 15 seconds

    • Minimum SVs: 1

    • File duration: 24 hours (creates daily files)

    • Automatically start logging data upon power-up

    This configuration creates daily (24 hour) data files starting and ending at 0:00:00 UTC. The receiver automatically starts logging upon power-up, which is important for remote sites that may lose power, e.g. at night, but regain power, e.g. in the day once the solar panel has charged the battery bank.

How To’s and FAQ

Firmware

Check the firmware expiry date (pdf) to see which firmware version can be installed under the terms of your warranty.

Testing

 

Last modified: 2019-12-27  16:36:35  America/Denver