UNAVCO standard configuration file for the NetR8

The UNAVCO standard configuration file for the NetR8 is intended for use with firmware version 4.87. Do not use this file with earlier versions. Users should familiarize themselves with the details of the file and make changes according to their intended use.

The configuration file can be uploaded to the receiver using the web interface:

Select Receiver Configuration
Select Application Files
Choose Upload Clone File from the Operation menu.
Select the configuration file that you would like to upload.
Select "Ok"

Note #1: After uploading the configuration file you may then enable/disable additional features with caution through the Receiver Configuration menu. Please refer to the user guide, which is available for download on the NetR8 resource page, for additional information regarding configuration.

Note #2: We used Firmware Version 4.87 to generate this config file.

Note #3: GLONASS hass been excluded as it is not included in the default options purchased by UNAVCO.

UNAVCO Standard Configuration Summary:

Elevation Mask: 0°
PDOP Mask: 99
Horizontal Precision: 0.30 [m]
Vertical Precision: 0.30 [m]
Clock Steering: Enabled
Everest™ Multipath Mitigation: Disabled
Antenna Type: Zephyr Geodetic 2
Antenna Measurement Method: Antenna Phase Center
Antenna Height: 0.000 [m]
1PPS On/Off: Disabled
Event 1 On/Off: Disabled
Event 1 Slope: Positive
External Frequency Available: Disabled
RTK Mode: Low Latency
Motion: Static
CMR Input Filter: Disabled
RTCM 2.x ID: 0
RTCM 3.x ID: 0
CMR ID: 0
Station Name: UNAVCO
Ethernet IP: 192.168.1.2
DNS Resolved Name: Not Set

Sessions installed with this clone file:

Session Name	Sample Rate	Duration	Enabled	Pool	File System	Path Style	Name Style	FTP Push	Email Push
DEFAULT	15 sec	1440 min	No	Delete when full 1000 MB (~ 1000 days)	Internal	YYYYMM/Session	##########YYYYMMDDhhmm	No	No
a	30 sec	1440 min	Yes	Delete when full 1000 MB (~2000 days)	Internal	YYYYMM/Session	##########YYYYMMDDhhmm	No	No
b	1 sec	60 min	No	Delete when full 2000 MB (~200 days)	Internal	YYYYMM/Session	##########YYYYMMDDhhmm	No	No

Tracking

GPS	L1 - CA	Enabled
GPS	L2 - Legacy	Enabled
GPS	L2 - CS	Enabled
GPS	L5	Enabled
SBAS	L1 - C/A	Disabled
SBAS	L5	Disabled
GLONASS	L1 - C/A	Disabled
GLONASS	L1 - P	Disabled
GLONASS	L2 - C/A(M)	Disabled
GLONASS	L2 - P	Disabled

General

Internal Battery UPS: Disable
UPS Timeout (seconds): 35
Power Over Ethernet: Disable
Power On Voltage: 11.0 V
Shutdown Voltage: Enable; 9.5 V
VFD Configuration: Enable
VFD Power Saver: Enable
VFD Brightness: 25%
VFD Rotation: Disable

Language

English

OmniSTAR

Signal Source: Demodulator
SV name: Auto
Setting: Off
Mode: Off
Preffered Source of Data: External
External OmniSTAR Data: Don’t Use
Internal OmniSTAR Demodulator: Off
Seed with RTK: No
NAD83->ITRF Transformation: No