Telebit Worldblazer - Suggested Register Settings Using a Direct Connection
Telebit Worldblazer - Suggested Register Settings Using a Direct Connection
Trimble 4000 SSE/SSi
Below are the suggested settings of the Telebit Worldblazer when directly attached to a Trimble 4000 SSE/SSi receiver and using the Trimble "rfile -f" program. The modem is set at 9600 baud and v.32 transfer protocol.
WorldBlazer - SA - Version LA7.02 - Active Configuration
B1 E0 L2 M1 P Q0 V1 X1 Y0 &C0 &D0 &G0 &J0 &L0 &Q0 &R3 &S0 &T4 &X0 S000:1 S001=0 S002=43 S003=13 S004=10 S005=8 S006=2 S007:40 S008=2 S009=6 S010=14 S011=70 S012=50 S018=0 S025=5 S026=1 S038=0 S041=0 S045=0 S046=0 S047=4 S048=0 S050=6 S051:4 S056=17 S057=19 S058:0 S059=0 S060:1 S061=1 S062=15 S063=0 S064:1 S068=255 S069=0 S090=0 S092=0 S093=8 S094=1 S100=0 S104=0 S105=1 S111=255 S112=1 S113=126 S114=0 S115=0 S151=4 S155=0 S180=2 S181=1 S183=25 S190=1 S191=7 S253=10 S254=1 S255=1Receiver set up: BAUD RATE / FORMAT = 9600, 8, NONE, 1, no flow control REMOTE PROTOCOL = DATA COLLECTOR COMPATIBLE Attach the receiver to the remote modem via a null modem cable.
AOA TurboRogue
Below are the settings of the Telebit Worldblazer used in the Kodiak, AK. This modem was attached to an AOA TurboRogue receiver. Data was downloaded to Boulder daily during the length of the project.
WorldBlazer - SA - Version LA7.02 - Active Configuration
B1 E0 L2 M1 P Q0 V1 X1 Y0 &C0 &D0 &G0 &J0 &L0 &Q0 &R3 &S0 &T4 &X0 S000:1 S001=0 S002=43 S003=13 S004=10 S005=8 S006=2 S007:120 S008=2 S009=6 S010=14 S011:120 S012:100 S018=0 S025=5 S026=1 S038=0 S041:1 S045:255 S046=0 S047=4 S048=0 S050:255 S051:4 S056=17 S057=19 S058:0 S059=0 S060=0 S061=1 S062=15 S063=0 S064:1 S068=255 S069=0 S090=0 S092=0 S093=8 S094=1 S100=0 S104=0 S105=1 S111=255 S112=1 S113=126 S114=0 S115=0 S151=4 S155=0 S180=2 S181=1 S183=25 S190:0 S191=7 S253=10 S254=1 S255=1