Vaisala - How to configure a Trimble NetRS for use with a Vaisala WXT510 metpack in the Plate Boundary Observatory

How to configure a Trimble NetRS for use with a Vaisala WXT510 metpack in the Plate Boundary Observatory

  1. Create ’Met_Z’ data logging session and enable

    • continuous logging

    • file duration ’60’min

    • T00 ’off’ Binex ’on’

    • Binex options

      • Measurements

        • ’15 Sec’ interval

        • all optons ’off’

        • System Status Record ’off’

      • Metadata

        • ’30 Min’ interval

        • Site decription ’on’

        • Station ID ’on’

        • Firmware Version ’on’

        • All others ’off’


    • File naming (The Session Identifier) ’z’

    • Directory options ’Create Per-SessionID subdirectories’

  2. Set reserve space for ’z’ session data.

    • Set Autodelete to ’10’ MBytes

    • Set pool ’z’ size to ’100’ MBytes and enable Autodelete

    • Reset pool ’c’ size to ’500’ MBytes

  3. Set I/O SerialPort 2 and enable

    • Service ’Met-Tilt’

    • Baud 19200

    • Parity ’None’

    • Flow Control ’None’

    • Parameters for Met/Tilt mode
      0R0    1 minutes

Posted by: Beth Bartel - November 20, 2009. This article has been viewed 513 times.
Online URL: https://kb.unavco.org/article/vaisala-how-to-configure-a-trimble-netrs-for-use-with-a-vaisala-wxt510-metpack-in-the-plate-boundary-observatory-534.html

Powered by PHPKB (Knowledge Base Software)