PC/104 - PC/104 Processor Specifications

PC/104 Processor Specifications


Processor board is shown next to a floppy disk for size comparison.

Electrical Specifications

1.1

Bus Interface PC/104 8-bit or 16-bit expansion Bus
System Clock Factory configured for 133 MHz
Interrupts TTL level input
VCC +5V +/-5% at 1300mA typical at 133MHz and 32MB DRAM
VCC1 +12V +/-5% (Not required. PC/104 Expansion only)
VCC2 -12V +/-5% (Not required. PC/104 Expansion only)

Memory

1.2

Addressing 32 Megabyte addressing
BIOS ROM 128K PEROM
Memory Factory installed SMT DRAM in sizes from 8M to 32M
SSD Memory One 32-pin JEDEC standard sockets support 4-MBit SRAM, 4MBit PEROM, 4-MBit EPROM, 16-MBit EPROM or the M-Systems 32-pin DOC (DiskOnChip) module

Mechanical

1.3

Dimensions 3.6 * 3.8 (without PC/104 modules or cables)
PC-Board FR4 Epoxy Glass with 4 signal layers and 2 power planes with screened Component legend, and plated through holes
Jumpers 0.025" square posts on 0.10" centers
Connectors Mulit I/O -- 50 pin RN type IDH-50-LP

Floppy Disk -- 34 pin RN type IDH-34-LP

Fixed Disk -- 40 pin RN type IDH-40-LP

PC/104 BUS -- 64 pin SAMTEC type ESQ-132-12-G-D
40 pin SAMTEC type ESQ-120-12-G-D

Power/Reset Connector -- 8 pin Molex 22-12-2084

Mouse -- 5 pin latching type Molex 22-12-2054

Speaker -- 3 pin latching type Molex 22-12-2034

Environmental

1.4

Operating Temperature -40 to +70
Non-Condensing Humidity 5% to 95%
Posted by: Beth Bartel - September 3, 2010. This article has been viewed 389 times.
Online URL: https://kb.unavco.org/article/pc-104-pc-104-processor-specifications-438.html

Powered by PHPKB (Knowledge Base Software)