| UNAVCO
 


Knowledge Base
Application Notes Articles RSS Feed
Trimble NetRS - UNAVCO Basic Use Guide
Viewed 32893 times since Wed, Jan 27, 2010
Trimble NetRS - UNAVCO Basic Use Guide UNAVCO, 2007 The purpose of this guide is to walk UNAVCO users through common tasks on the Trimble NetRS. A complete Trimble NetRS user guide is also available. Table of contents: A. Setting the receiver's... Read More
Trimble NetRS - How to reset the receiver and reload the kernel
Viewed 12314 times since Mon, Jan 12, 2009
Trimble NetRS - How to reset the receiver and reload the kernel This article explains how to reset the Trimble NetRS receiver and reload the kernel. There are two way to do this: Power on the receiver and hold the power button for 30+ seconds... Read More
Trimble NetRS - How to connect to the NetRS receiver using DHCP
Viewed 5901 times since Sun, Jan 11, 2009
How to connect to the NetRS receiver using DHCP The easiest way to configure a NetRS is through the receiver's web interface. You can aquire an IP address using DHCP or assign an IP address via its serial port. To assign an IP address using the... Read More
Trimble NetRS - How to set up a PPP connection to a NetRS using LINUX and WvDial
Viewed 4529 times since Tue, Jan 13, 2009
How to set up a PPP connection to a NetRS using LINUX and WvDial Use the LINUX command "wvdial SITE", where SITE is the dialer specified in the wvdial.conf file (e.g. [Dialer unavco]). See below. REMOTE MODEM SETTINGS USRobotics Courier V... Read More
Trimble NetRS - How to configure an XP computer to connect to a NetRS via PPP
Viewed 3068 times since Sun, Jan 11, 2009
How to configure an XP computer to connect to a NetRS via PPP Under “Network Connections” on your PC, create a new connection and select the following: Connect to the internet Set up my connection manually Connect using a dial-up modem... Read More

Last modified: Monday, 12-May-2014 00:18:29 UTC