| UNAVCO
 


Knowledge Base

Digitizing Resolution of the Trimble NetR9 Receiver

Digitizing Resolution of the Trimble NetR9 Reciever

While differencing the L2 and L2C carrier phase measurements made with a NetR9 receiver, we have observed a banding pattern; the difference between each band is ~0.0009765625 (1/1024) cycles.

This banding demonstrates that the digitizing resolution of the NetR9 receiver is 1/1024 (1/2^10) of a cycle - the receiver is using an 10 bit A-D conversion.

This analysis was done using a translation of RT27-format data using extended resolution on the phase values beyond the usual 0.001 cycle resolution available in RINEX observation format.

The following figure shows the difference between the L2 and L2C carrier phase measurements for PRN 7 from a NetR9 receiver.

Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Trimble NetRS - tracking behavior changes after firmware upgrade
Viewed 2360 times since Thu, Mar 10, 2011
Digitizing Resolution of the Septentrio PolaRx3e Receiver
Viewed 2499 times since Tue, Mar 8, 2011
GNSS Receiver Evaluations 2012
Viewed 6895 times since Wed, Jul 11, 2012
AOA Receivers Benchmark Test (1998)
Viewed 4316 times since Thu, Sep 10, 2009
UNAVCO GNSS Receiver Preferred Vendor RFP Evaluation Report
Viewed 4177 times since Thu, Oct 1, 2015
Topcon GB-1000 First Article Receiver Testing
Viewed 3531 times since Thu, Oct 30, 2008
Digitizing Resolution of the Javad Sigma Receiver
Viewed 1718 times since Tue, Feb 15, 2011
Digitizing Resolution of the Leica GR10 Receiver
Viewed 3827 times since Thu, Feb 3, 2011
Custom Cavity-Type Notch Filter for Mitigating GPS/GNSS Interference from Iridium Data Transmitters
Viewed 44425 times since Mon, Oct 24, 2011
Digitizing Resolution of the Trimble NetRS Receiver
Viewed 2422 times since Fri, Feb 4, 2011
MENU
 

Last modified: 2019-12-27  16:36:35  America/Denver