Knowledge Base

Digitizing Resolution of the Trimble NetR8 Receiver

Digitizing resolution of the Trimble NetR8 receiver

While differencing the L2 and L2C carrier phase measurements made with a NetR8 receiver, we have observed a banding pattern; the difference between each band is ~0.0009765625 (1/1024) cycles.

This banding demonstrates that the digitizing resolution of the NetR8 receiver is 1/1024 (1/2^10) of a cycle - the receiver is using an 10 bit A-D conversion.

This analysis was done using a translation of RT27-format data using extended resolution on the phase values beyond the usual 0.001 cycle resolution available in RINEX observation format.

The following figure shows the difference between the L2 and L2C carrier phase measurements for PRN 7 from a NetR8 receiver.

Attached Files
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Security Code Security Code
Related Articles RSS Feed
Digitizing Resolution of the Javad Sigma Receiver
Viewed 1834 times since Tue, Feb 15, 2011
GNSS Receiver Evaluations 2012
Viewed 7204 times since Wed, Jul 11, 2012
Iridium & GPS/GNSS Inteference from Iridium Data Transmitters
Viewed 20621 times since Mon, Oct 24, 2011
AOA Receivers Benchmark Test (1998)
Viewed 4926 times since Thu, Sep 10, 2009
Digitizing Resolution of the Septentrio PolaRx3e Receiver
Viewed 2598 times since Tue, Mar 8, 2011
Power Draw Profile for Trimble NetRS and Iridium Systems
Viewed 6781 times since Sat, Aug 28, 2010
UNAVCO 2003 GPS Receiver and Antenna Testing in Support of the Plate Boundary Observatory (PBO)
Viewed 4179 times since Thu, Jul 16, 2009
Custom Cavity-Type Notch Filter for Mitigating GPS/GNSS Interference from Iridium Data Transmitters
Viewed 45269 times since Mon, Oct 24, 2011
Topcon GB-1000 First Article Receiver Testing
Viewed 3643 times since Thu, Oct 30, 2008
Trimble NetRS - tracking behavior changes after firmware upgrade
Viewed 2487 times since Thu, Mar 10, 2011

Last modified: 2019-12-27  16:36:35  America/Denver