| UNAVCO
 


Knowledge Base

Trimble 4000 - Quick Start Guide

Quickstart for the Trimble 4000 Receiver

UNAVCO 8/02

This is an outline of the steps needed to run a quickstart survey with the Trimble 4000 SSE and SSi receivers. It is only intended as a guide - refer to the manual for more detail.

  1. Turn on receiver.

  2. Press LOG DATA.

  3. If in doubt, press MORE - SETUP SURVEY CONTROLS - MODIFY QUICKSTART CONTROLS to set/ACCEPT elevation mask, measurement sync time, and optional continuous logging mode. ("Store Position:" should be set to NORMALLY for most applications, "Minimum SVs:" should be set to 3.)

  4. Press QUICK START NOW! (SINGLE SURVEY) to start survey.

  5. Press LOG DATA - CHANGES - ANTENNA HEIGHT/FILE NAME to enter antenna height and file name.

  6. Press STATUS to return to main status screen.

  7. Press LOG DATA - END SURVEY - YES to end survey.

Attached Files (1)
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Trimble 4000 - How to configure for kinematic surveys
Viewed 7122 times since Fri, Dec 11, 2009
Trimble 4000 - Typical Short- and Long-term Power Configurations (2 diagrams)
Viewed 4490 times since Fri, Dec 11, 2009
Trimble 4000 series - Trimble Support Notes
Viewed 1986 times since Mon, Dec 14, 2009
Trimble 4000 series - How to replace internal batteries
Viewed 1820 times since Fri, Dec 11, 2009
TRIM4000 - How to download using TRIM4000 for DOS
Viewed 8223 times since Fri, Dec 11, 2009
Trimble 4000 - How to program survey sessions
Viewed 14626 times since Fri, Dec 11, 2009
MENU

Last modified: Monday, 12-May-2014 00:18:29 UTC