| UNAVCO
 


Knowledge Base

Intuicom - How to load firmware onto an Intuicom EB-1 ethernet bridge

How to load firmware onto an Intuicom EB-1 ethernet bridge

Note: To use CommPro 1.1.7, you must use firmware DREV264.exe or greater. Do not load / use any firmware older than 2.54.

  1. Connect the radio to a PC with an available serial port via a programming/diag cable. Make sure the radio is powered up.

  2. Run the firmware executable (double-click on .exe).

  3. Select your comm port (option 3). If needed, hit Enter to keep the default baud rate.

  4. Select Update firmware (option 1).

  5. Answer yes (y) at the three prompts (set up mode, diag, high rate).

  6. Wait 30-60 seconds for the program to run; it will tell you when the update is complete.


Download firmware:

 

eb,bab2009

Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Intuicom EB-3 Plus Frimware 2.4.i125
Viewed 1131 times since Fri, Jun 3, 2011
Intuicom EB-1 Firmware 2.64
Viewed 1377 times since Tue, Mar 24, 2009
Intuicom Firmware 5.82
Viewed 1392 times since Tue, Mar 24, 2009
How to upgrade to Intuicom firmware Rev. 5.80, 2001
Viewed 8112 times since Tue, Mar 24, 2009
Intuicom Firmware 5.80
Viewed 1389 times since Tue, Mar 24, 2009
Intuicom EB-6 Plus Frimware 2.4.i125
Viewed 1163 times since Fri, Jun 3, 2011
Intuicom EB-1 Firmware 2.54
Viewed 1472 times since Tue, Mar 24, 2009
MENU

Last modified: Monday, 12-May-2014 00:18:29 UTC