Knowledge Base

The Role of Multipath in Antenna Height Tests at Table Mountain (paper, 1995)

The Role of Multipath in Antenna Height Tests at Table Mountain

James Johnson, John Braun, Chris Rocken, Teresa VanHove
July, 1995


In order to determine what effect the antenna height has on baseline horizontal and height components, data were collected on short (~5 meters) baselines at the Table Mountain Antenna Range. These data were analyzed, and height biases of 1.0 to 1.7 cm were found between baselines with high and low antenna setups when tropospheric parameters were estimated. Horizontal components did not change. When both ends of the baseline were occupied with the same height setups, no bias was seen, although the repeatabilities for low-low antenna setups were worse than for high-high setups. This paper will show that the height bias in high-low antenna baselines is the result of multipath at the low antenna being mismodeled as troposphere. First we construct a simplified model of multipath phase and amplitude error as a function of antenna height. To verify this model we compare the predicted amplitude pattern for low and high antenna setups to the signal- to-noise ratio recorded by the GPS receivers. We then show that the multipath phase error generated by a low antenna setup correlates to a tropospheric signal for large intervals of elevation. In specific, the L1 phase error for an antenna height of 24 cm shows a strong correlation to a tropospheric delay in the elevation range of 17.5 to 29.0 degrees. This range of elevation is sensitive to both multipath and tropospheric errors. We also see that multipath from near ground reflections have a long period (> 1 hour) which makes them less likely to average out over time. We then briefly discuss the possibility of modeling and/or identifying the multipath in the low antenna setup. Based on our simple multipath model and experimental results, we conclude for environments such as Table Mountain that: (1) GPS antennas should not be placed near the ground because the multipath phase error is of low frequency and can be mismodeled as a tropospheric delay, (2) The multipath from the low antenna setup can not be easily modeled or corrected, and (3) GPS antennas mounted on tripods 1.5 meters above the ground suffer from high frequency multipath that can not be modeled as a tropospheric parameter and therefore does not effect the baseline determination.

[See attached .pdf file for more.]

Attached Files (1)
There are no comments for this article. Be the first to post a comment.
Security Code Security Code
Related Articles RSS Feed
Preliminary Report on Data Quality with a Trimble 5700 GPS Receiver and an Ashtech Choke Ring Antenna (2002)
Viewed 5009 times since Wed, Dec 3, 2008
Trimble TRM59900 Ti-Choke Ring GNSS Antenna Test Report
Viewed 8582 times since Wed, Oct 2, 2013
GNSS Antenna Sensitivity to Site Dependent Error Sources
Viewed 86226 times since Thu, Jan 31, 2013
Custom Cavity-Type Notch Filter for Mitigating GPS/GNSS Interference from Iridium Data Transmitters
Viewed 44063 times since Mon, Oct 24, 2011
An Improved GPS Geodetic Antenna (1996)
Viewed 3123 times since Wed, Mar 24, 2010
GNSS Antenna Signal to Noise Comparison
Viewed 44476 times since Wed, Nov 26, 2014
Trimble Choke Ring Antenna Mean Phase Center Calibration (1996)
Viewed 5690 times since Fri, Oct 31, 2008
Choke Ring Antenna Calibrations
Viewed 22455 times since Wed, Mar 24, 2010
1995 UNAVCO Antenna Height Tests
Viewed 3178 times since Wed, Mar 24, 2010
GPS Receiver and Antenna Testing Report for SuomiNet (2000)
Viewed 4775 times since Wed, Mar 24, 2010

Last modified: 2019-12-27  16:36:35  America/Denver