Trimble NetR9 - How to enable an external frequency source

To fully enable an external frequency source:

1) Attach a 10MHz external frequency source to the BNC port (2) on the rear of the receiver. 

netr9_rear_connectors.png

2) Disable clock steering (Receiver Configuration -> Tracking -> Clock Steering)

netr9_tracking_steering.png

3) Enable External Frequency (Receiver Configuration -> General -> External Frequency)

netr9_general_external.png

Posted by: Henry Berglund - February 27, 2014. This article has been viewed 637 times.
Online URL: https://kb.unavco.org/article/trimble-netr9-how-to-enable-an-external-frequency-source-779.html

Powered by PHPKB (Knowledge Base Software)