Suggested configuration for a FreeWave DGR-115H radio modem connected to a Trimble 4000SSE/SSi GPS receiver |
NOTE: The outdated and offensive "master-slave" terminology has been replaced with "Access point (AP) - Station/Endpoint (STA)" in all instances, but will still remain in the configuration software when implemented.Below are the suggested settings of the FreeWave Wireless Data Transceiver when directly attached to a Trimble 4000 SSE/SSI receiver and using the Trimble "rfile" program. The modem is set at 38400 baud.Base Modem:Operation mode: Point to Point Master
Remote Modem:Operation modem: Point to Point Slave Remote Receiver:BAUD RATE/FORMAT CONTROL MENU set to 38400, 8, N, 1, no flow control. REMOTE PROTOCOL MENU set to DATA COLLECTOR COMPATIBLE. Attach the receiver to the remote modem via a null modem cable. |
Posted by: Beth Bartel - July 8, 2009. This article has been viewed 269 times. |
Online URL: https://kb.unavco.org/article/suggested-configuration-for-a-freewave-dgr-115h-radio-modem-connected-to-a-trimble-4000sse-ssi-gps-receiver-431.html |
Powered by PHPKB (Knowledge Base Software)